The Quantum Hall Effect is a phenomenon that occurs when electrons move through a very thin, very...
Electronics
A Wireless Mesh Network (WMN) is a type of wireless network made up of multiple devices that...
In electronics, a filter is a circuit that allows certain frequencies of a signal to pass through...
An electromechanical system is any system that uses both electricity and mechanical parts to perform a function....
Nanoelectronics is a field of electronics that deals with the design and use of extremely small electronic...
A coil is simply a wire wound into loops or turns. Coils are used in many electrical...
Low Earth Orbit (LEO) refers to a region of space where satellites orbit the Earth relatively close...
electromagnetic field simulation is a technique used to analyze and predict how electromagnetic fields behave in and...
An amplifier is an electronic device that increases the amplitude of a signal, such as an audio...
Touchscreen technology allows you to interact directly with a device's display by touching the screen. Instead of...
Embedded firmware development is the process of writing software that runs on embedded systems, controlling hardware to...
A comparator is an electronic device that compares two voltages (or signals) and then outputs a signal...
Clipping is when a diode is used to cut off part of a signal to limit its...
In communication systems, a phase shifter is a device used to change the phase of a signal...
Communication via Infrared (IR) Light is a way of sending information using infrared light waves instead of...
Microcontroller programming languages are used to write code that makes a microcontroller perform tasks like controlling sensors,...
Digital smoothing techniques are used to make signals clearer by reducing unwanted noise and fluctuations. The most...
Resistor-Transistor Amplifier (RTA)
Amplifier
Weak electrical signals
Transistor
Resistor
Bias
Voltage amplification
Signal strength
Common Emitter Amplifier (CE)
Common Collector Amplifier (CC)
Emitter follower
Impedance matching
Common Base Amplifier...
Integrated Circuit (IC) Testing Techniques are methods used to check if an IC (a tiny electronic circuit,...
Radar Waveform Design is about creating and choosing the right type of signal (called a "waveform") for...
